|
STARBAR-Heating Elements are produced from recrystallised silicon carbide.
The high density of 2,4 g/cm3 assures a maximum of durability and a high strength.
The nominal element-resistance is measured at a temperatur of 1071 °C.
The possible element-power depends upon the furnace-temperature and furnace-atmosphere.
The aluminium metallized cold-ends assure a proper electrical contact for the
current entry.
Type: DB
Element with enlarged thickened cold-ends. The element consists of a high-resistance hotzone and two
sintered cold-ends, which have, because of its bigger cross-section, a essential lower resistance-value
as the hotzone.
Type: SE
Is build out of a tube with a spiral cutted in. This spiraled area represents the hotzone of the element,
which has instead of the cold ends a very high resistance. Elements with separated
hotzones are possible.
Type: RR
Element with a constant diameter along the whole length. The element is build of a hotzone
in the middle and two cold ends, which are metallized with aluminium, to reduce the
resistance and the temperature in the cold-ends.
Type: SER
Because of the bifilar spiral-builded hotzone the both cold-ends are located at one
side of the element. So this form of element is specially suitable for furnaces which are
difficult to access. SER-elements will be delivered with flexible terminal-clamps.
Type: U und W
Is build out of two parallel fixed heating elements which are connected through a low resistance bridge circuit
of SIC. Each heating element is partitioned into a hotzone and a zone of cold ends.
The U-element is used for a 1-phase-element and the W-element for a 3-phase-element.
Type: TSR
Is a thinwalled model of the bifilar spiral-element for the application of a muffle type furnace.
Because the annealing-good is fully surrounded from the heating element, it is specially suitable
for the application of thermical analyses, calibration of thermocouple, etc.
The two electrical terminals are located at one side.
mountings and mating components:
- screwed terminal clamps
- mounting parts for terminal-straps, form M and W
(M = for manual mounting, W = for mounting with tools
- terminals made of flexible aluminium-strand
Typ A: from heating element to voltage supply source
Typ B: for serial connection
Typ C: for strap-extension
dimension:
| typ |
diameter
mm |
annealing-zone
mm ca. |
total length
mm ca. |
working temperatur °C |
| air/ inert gas |
reduc. atmosphere |
DB
RR
SE
SER
TSR |
8-54
9,5-70
12-70
12-70
45-75 |
60-1500
120-~4000
120-1550
100-1020
150-300 |
160-2500
300-4650
300-2360
230-1550
350-600 |
1540
1700
1650
1650
1650 |
1370
1370
1370
1370
1370 |
back |
Berghütten®
